How to Hardwire Interior LED Car Lights

Posted on: May 31, 2018, by :

How to Replace a Buick Regal Headlight Assembly Bulb

How to Fix Dashboard Lights That Wont Light

Connect the positive terminal of your car battery to 12-gauge AWG cable.

How to Hardwire Interior LED Car Lights

Connect the 12-gauge AWG cable to an in-line fuse, per fuse manufacturers instructions. The in-line fuse protects your LED lights from any excessive, and potentially dangerous, infusions of voltage from the car battery. Locate the fuse within 18 inches of the battery, but as far away as possible from the car engine and from any particularly hot areas of the hood.

How to Hardwire Interior LED Car Lights

How to Charge a 6-Volt Positive Ground Battery

Connect the control switch, using 12-gauge AWG cable, to the interior LED lights.

Connect the 12-gauge AWG cable to the control switch, per manufacturers instructions.

Tricia Lobo has been writing since 2006. Her biomedical engineering research, Biocompatible and pH sensitive PLGA encapsulated MnO nanocrystals for molecular and cellular MRI, was accepted in 2010 for publication in the journal Nanoletters. Lobo earned her Bachelor of Science in biomedical engineering, with distinction, from Yale in 2010.

Reconnect your car battery. When you ignite your engine, you should be able to use the control switch to turn your LED lights on and off at will.

What Voltage Is the Battery in a Car?

How to Test a Car Voltage Regulator

Removing a Brake Booster Vacuum Hose

All Neon Car Lights: Basic Generic Instructions on how to Install Interior Car Lights into Your Vehicle

Where Is the Fuse Box Inside the Car?

Disconnect your car battery before you start working.

If wired incorrectly, electrical circuits can cause harm, and even death. Do not attempt this procedure before consulting an experienced professional.

Interior LED lights, which provide lighting across a variety of wavelengths and degrees of brightness, offer convenience, safety, and the possibility of customizing your vehicle. LED lights offer myriad advantages, including their small size, longer lifetime, relatively low energy consumption compared to their incandescent counterparts, faster switching, and high reliability. After mounting your LED lighting kit, the process of wiring your lights is relatively straightforward, requiring only limited materials that you can obtain at your local hardware store.

Drill a hole in the firewall of your car, which separates your engine from the interior of your car. Fill the hole with rubber grommet, preventing the 12-gauge AWG cable from rubbing against the metal of your car and potentially damaging both. Pull the 12-gauge AWG cable through the hole in the firewall.

Leave a Reply